假目标诱骗对抗反辐射导弹作战效能分析

研究多个假目标保护一个真目标(雷达)对抗反辐射导弹(ARM)的作战效能.在确定ARM瞄准方向的基础上,给出导引头在分辨目标时刻对真假目标截获概率的计算方法;推导出计算真目标受到ARM多次攻击时被杀伤概率的通用公式.研究结果表明:在评估假目标诱骗对抗ARM的效能时,必须考虑目标损失积累的影响;为提高诱骗效能,在增加假目标数量的同时,应降低其易损性,提高发射功率,并采用合理的布局方案.     

飞机系统可靠性的电磁兼容预测研究

对飞机可靠性工程中的有关系统内电磁瘘容性分析和预测程序进行了研究开发，详细论述了天线对天线干扰的传播模型、导线与导线间的耦合模型、电磁场对导线的感应模型、设备对设备的耦合模型以及其编程语言、输入数据处理方法等开发技术。给出其计算结果，并与实验数据作了比较，结果表明，可提高系统的可靠性。     

神舟2号大气密度探测器的探测结果(Ⅰ)日照和阴影区域热层大气密度变化

选用了神舟2号（SZ-2）大气密度探测器在2001年2—4月间的探测数据,进行日照和阴影区域热层大气密度变化的探讨.结果表明:在高度410km附近,日照和阴影区域大气密度变幅为2—3倍,变幅的大小与地磁活动程度呈负相关关系.日照面大气密度峰区位于星下点地方时1400—1500LT的纬度处,峰值大小与太阳活动程度呈正相关关系.阴影面大气密度谷区位于星下点地方时0400-0500的纬度处,同时在±10°纬度区域中还出现了阴影面峰区.     

MONITORING OF ENERGETIC PARTICLE ENVIRONMENT INSIDE THE CHINA-BRAZIL EARTH RESOURCE SATELLITE

On 14 October 1999, the Chinese-Brazil earth resource satellite (CBERS-1) was launched in China. On board of the satellite there was an instrument designed at Peking University to detect the energetic particle radiation inside the satellite so the radiation fluxes of energetic particles in the cabin can be monitored continuously. Inside a satellite cabin, radiation environment consists of ether penetrated energetic particles or secondary radiation from satellite materials due to the interactions with primary cosmic rays.Purpose of the detectors are twofold, to monitor the particle radiation in the cabin and also to study the space radiation environment The data can be used to study the radiation environment and their effects on the electronics inside the satelhte cabin. On the other hand, the data are useful in study of geo-space energetic particle events such as solar proton events, particle precipitation and variations of the radiation belt since there should be some correlation between the radiation situation inside and outside the satellite.The instrument consists of two semi-conductor detectors for protons and electrons respectively. Each detector has two channels of energy ranges. They are 0.5-2MeV and ≥2MeV for electrons and 5-30MeV and 30-60MeV for protons. Counting rate for all channels are up to 104/(cm2@s)and power consumption is about 2.5 W. There are also the additional functions of CMOS TID (total integrated dose) effect and direct SEU monitoring. The data of CBMC was first sent back on Oct. 17 1999 and it's almost three years from then on. The detector has been working normally and the quality of data is good.The preliminary results of data analysis of CBMC not only reveal the effects of polar particle precipitation and radiation belt on radiation environment inside a satellite, but also show some important features of the geo-space energetic particle radiation.As one of the most important parameters of space weather, the energetic charged particles have great influences on space activities and ground tech nology. CBMC is perhaps the first long-term on-board special equipment to monitor the energetic particle radiation environment inside the satellite and the data it accnmulated are very useful in both satellite designing and space research.     

The origin of the prompt optical emission in GRB 060111B

The detection of a bright optical emission measured with good temporal resolution during the prompt phase makes GRB 060111B a rare event that is especially useful for constraining theories of the prompt optical emission. Comparing this burst with other GRBs with evidence of optical peaks, we find that the optical peak epoch (t_p) is anti-correlated with the high energy burst energetic assuming an isotropic energy release (E_iso) in agreement with Liang et al. (2009), and that the steeper is the post-peak afterglow decay, the less is the agreement with the correlation. GRB 060111B is among the latters and it does not match the correlation. The Cannonball scenario is also discussed and we find that this model cannot be excluded for GRB 060111B.     

火星表面热环境对航天器热控影响分析

火星大气对太阳辐射产生吸收和散射作用，同时还将与火星表面航天器发生对流换热。热设计时难以直接评估对流、辐射和导热三种换热对航天器的影响，从而确定主要的控温途径。在调研火星表面辐射、大气等热环境的基础上，从线性化传热系数和对流辐射比的角度对比分析了辐射、对流和导热对航天器的影响。器表辐射传热系数随光学属性和温度的变化范围为0.3～1.4W/(m2·℃)，对流传热系数随风速变化为0.2～1.5W/(m2·℃)，器内导热传热系数可控制在0.25W/(m2·℃)以下。结果表明，太阳辐射较火星表面和天空辐射而言是主要外热源，航天器表面的辐射和对流换热为两条并联换热途径，两者均可成为主要换热途径，器内导热传热是控制航天器内外隔热的主要可控因素。     

Microstructure,porosity and mechanical properties of selective laser melted AlSi10Mg

Finite element modeling (FEM), microscopy, X-ray computed tomography (CT) and mechanical property tests were used to study the microstructure, porosity and mechanical properties of an AlSi10Mg alloy produced by selective laser melting (SLM). The simulation of the melt pool and thermal history under different energy densities produced an optimized result with an energy density of 44.5 J·mm⁻³. The high cooling rate during the SLM process significantly refined the previous α-Al dendrites. The growth direction of the network-like Al-Si eutectic structure at different orientations confirmed the anisotropic nature of the microstructure. Furthermore, the microhardness, tensile testing and fracture analysis results proved that there were no obvious distinctions in the strength between the transverse and longitudinal directions, and that the ductility was anisotropic, possibly due to the shape and distribution of the pores. The pores measured by X-ray CT at different energy densities confirmed that the sphericity of the pores was inversely related to pores volumes. With optimized processing conditions, the porosity of the selective laser melted sample decreased leading to the improved fabricated fuel system component via SLM.     

空间激光通信系统中的信道纠错编码技术

由于空间激光通信系统的信道状态和链路捕获跟踪的不确定性,多种形式的信道纠错编码技术正被广泛发展研究。结合空间激光通信链路中误码性能的主要影响因素,分别选择合适的编码方案进行分析。通过仿真实验可知,对于在大气结构参数为1.5×10~(-14) m~(-2/3)、风速为20 m/s的空地激光链路的环境下,在系统数据速率为2 Gbit/s、要求误码率为10~(-6)时,LDPC码结合交织码相对未编码系统有3 dB的等效编码增益,LT码相对未编码系统有3.8 dB的等效编码增益。提供了一种能快速生成、扩展和校验的编码和交织实现方法,以抵抗大气湍流的快速变化对系统性能产生的影响。     

基于激光的便携式飞机装配接缝质量检测仪及应用

介绍了一种基于激光的便携式接缝质量检测仪的工作原理及硬件组成。使用该检测仪对飞机缝隙和台阶阶差进行了测量,通过与人工测量进行对比验证,证明了该装置可实现对特征三维信息的快速自动检测,工作准确可靠。